Someone sent me a link to the YouTube video below.
I have to admit I was not expecting much out of a 10-minute home video, but the?guy who produced it actually did a decent job at explaining the basics of how to do small fiberglass repairs, surface preparation and paint application.
As a side note, I prefer to use a small throw-away brush with stiff bristles to help the fiberglass resin permeate the cloth, but I guess everyone has their own approach.
Again, the video shows basic stuff which, oddly enough, are things that many experienced do-it-yourselfers tend to forget or simply ignore.
Having painted more than my share of cars, motorcycles, helmets, bicycles and who knows what else over the years, I can tell you that a good paint job depends on how well you've prepared the surface you intend to spray.
How good you are with a spray gun and how expensive the paint is will not guarantee a good finish. If you fail to properly do the necessary repairs, apply filler, sand the whole surface down till it's perfectly smooth, then apply a couple of coats of primer, lightly sand the whole area with wet fine sandpaper, then clean the part with alcohol followed by a tack cloth, the top coat will only magnify imperfections left behind for everyone to see.
There simply are no shortcuts to a great paint job.
Anyway, enjoy the video and good luck with your project!
Sources: Cousin Dan's channel | Motorcycle Painting How-To Books
san diego chargers san diego chargers j.r. martinez lance ball lance ball kansas city chiefs chiefs
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.